Is The Cricut Vinyl Shiny Side Down

The iron on vinyl is put onto the roll carrier side out which means the side that curls down is the carrier side and the side that curls up is the vinyl side in the end if you re faced with two shiny sides the same color the slightly less shiny side is going to be the vinyl side.

Is the cricut vinyl shiny side down.

The shiny side goes down when your cutting. So again that s shiny side down. You want to cut through the vinyl but not through the carrier sheet. Use a craft stick or scraper found in the cricut tool kit to burnish rub or polish the tape onto the vinyl.

There is a layer of plastic that will be peeled away. Mirror the image in the design program before cutting otherwise when you flip the vinyl the cut will be backwards. Whatever mat and machine you are using put your adhesive vinyl paper backing side down onto your mat so the colored vinyl side is facing up see image below. It makes it really easy.

Perform test cuts to get your settings correct and remember to reverse your image on your computer before cutting htv. Preparation with cricut transfer tape. It s the shinny side. Here is another example shinny carrier side hard to pick through the vinyl side.

Put the iron on vinyl shiny side down on the mat so you re cutting the back of the vinyl and not the carrier sheet. If your vinyl came on a roll you can cut off a piece to fit on your mat. Also it is why you put the shiny side down when you cut cricut iron on vinyl. Place vinyl liner side down onto cricut standardgrip mat.

The cricut cutting mats are really similar and i have used cricut mats with my silhouette. Then position it plastic side down and vinyl side up the more dull less shiny side. To prevent bubbles start in the center and move out toward the edges. Cutting vinyl with a cricut machine.

Remove the negative pieces from each of the images leaving the clear. Cut on iron on vinyl setting. There is no transfer tape required with cricut iron on vinyl because it is already hooked onto the vinyl. That means you are putting the shiny transfer tape on the sticky mat surface.

Refer to kiss cut guide below to adjust machine settings. The vinyl side goes face up.