Installing Vinyl Decals Wet

This is because there is no chance of application fluid being trapped between the vinyl decal and the vehicle surface leading to peeling and or water bubbles.

Installing vinyl decals wet.

The decal will not stick to itself when wet making it easier to handle during the installation and any bubbles that are trapped under the decal can easily be pushed out before the decal dries. Mix 1 or 2 drops of liquid dish soap in a spray bottle of water. It s not hard but does take a little bit of time. Here is the wet method used to apply larger stickers decals to eliminate air bubbles.

Small vinyl lettering and decals should be installed dry. The most common way to install decals is the dry method. Installing your own. Slower than the dry method but no air bubbles.

Because our vinyl adhesive is solvent based the soap solution will not affect the decal s ability to adhere to the surface once the solution has. Then proceed with the normal vinyl installation. By jennifer leclaire while it s true that the dry installation method of vinyl application saves time and money let s face it not every graphic installer has the necessary skills or experience. After cleaning your surface area wet the area again using a spray bottle and a solution of about 5 soap 95 water.

You can apply most smaller decals without using water but for large and very large stickers this trick is a life saver. Using the wet method is the best way to install a large vehicle decal or graphic to ensure a smooth bubble free finish. Don t get the paper liner under the vinyl adhesive wet. Dry installation vs wet installation.

Use the wet method. Apply the sticker while the area is still wet. The dry method will insure that your vinyl decal stays adhered to your vehicle surface. Spray your surface and the bottom of the vinyl after removing the liner with water.